what will affect compressive strength of concrete by using quarry dust

what will affect compressive strength of concrete by using quarry dust

Effect of Quarry Dust on High Performance Concrete

(2003) reported significant increase in compressive strength, modulus of rupture and split tensile strength when 40 percent of sand is replaced by Quarry Rock Dust in concrete. Nagaraj (2000) studied that the consumption of cement content, workability, compressive strength and cost of concrete made with Quarry Rock Dust.

Effect of quarry rock dust on the flexural strength of ...

Jun 01, 2018 · Abstract. The effect of quarry dust on the flexural strength of concrete has been experimentally studied and reported in this paper. Concrete used was prepared by replacing 25% and 100% of sand by weight with quarry dust. Also, conventional sand concrete was prepared as reference concrete for comparison. 100 mm cube and 100 × 100 × 500 mm ...

High performance concrete using quarry dust as fine aggregate

Concrete containing quarry dust as fine aggregate is promising greater strength, lower permeability and greater density which enable it to provide better resistance to freeze and thaw cycles and durability in adverse environment. The compressive strength of quarry dust concrete can be improved with admixture and also super

Use of Quarry Dust to Replace Sand in Concrete – An ...

Table 5.2 : Compressive strength of M25 concrete in 28 days due to temperature effect Fine aggregate Sand: Quarry dust Compressive strength (MPa) % of reduction in strength compared with control concrete Normal temperature After heated to 100°C 100:0 31.03 24.37 21.47 90:10 31.19 24.50 21.05 80:20 31.52 25.15 18.95

Effect of Quarry Dust on High Performance Concrete

(2003) reported significant increase in compressive strength, modulus of rupture and split tensile strength when 40 percent of sand is replaced by Quarry Rock Dust in concrete. Nagaraj (2000) studied that the consumption of cement content, workability, compressive strength and cost of concrete made with Quarry Rock Dust.

Stone Dust in Concrete: Effect on Compressive Strength

Quarry dust can be utilized in concrete mixtures as a good substitute for natural river sand giving higher strength at 50% replacement (Balamurgan et al ., 2013).

IMPACT OF QUARRY DUST & DOLOMITE POWDER ON

ABSTRACT-The purpose of this work is to describe the effect of quarry dust and dolomite on the compressive strength of concrete. The present examinations indicate that dolomite may be used as partial replacement of cement in concrete and quarry dust may be suitably replaced with fine aggregate in concrete to some extent.

Use of Quarry Dust to Replace Sand in Concrete – An ...

Table 5.2 : Compressive strength of M25 concrete in 28 days due to temperature effect Fine aggregate Sand: Quarry dust Compressive strength (MPa) % of reduction in strength compared with control concrete Normal temperature After heated to 100°C 100:0 31.03 24.37 21.47 90:10 31.19 24.50 21.05 80:20 31.52 25.15 18.95

(PDF) Use of Quarry Dust to Replace Sand in Concrete – An ...

20:80 0.525 0.415 10:90 0.530 0.419 Table 5: Mean Compressive strength of concrete due to thermo 0:100 0.540 0.425 shock B. Compression test Fine aggregate 28 days The cube specimens were tested for compressive strength at Sand: Quarry dust Compressive strength (

USE OF STONE DUST OR QUARRY DUST AS AN ALTERNATIVE TO ...

A paper on Stone Dust in Concrete: Effect on Compressive Strength. In the investigation, an experimental program was carried out to study the workability and compressive strength of concrete made using stone dust as partial replacement of fine aggregate in the range of 10% - 100%.

COMPARATIVE ANALYSIS OF STRENGTH OF CONCRETE USING

This project work focuses on the comparative analysis of strength of concrete using sharp sand from the bed of Unwana river in Afikpo North L.G.A and quarry dust from Amasiri Quarry site in Afikpo south L.G.A. all in Ebonyi state. The concrete mix design used was 1:2:4 and unicem cement was also used in carrying out the practical as regards to ...

(PDF) BEHAVIOUR OF CONCRETE ON THE USE OF QUARRY DUST

Quarry dust 60:40 18.20 20.2 5.82 6.32 often contains flat and elongated particles require an increase in mixing water and thus it affect the flexural strength of 50:50 18.80 20.6 9.31 8.43 concrete if the water cement ratio is not adjusted.

Effect of Marble Powder and Quarry Dust as Partial ...

Nov 22, 2019 · The compressive strength of concrete using partial replacement of quarry dust and marble powder as fine aggregate gives about 30% to 40% more strength than that of conventional concrete

Compressive strength study of Geopolymer Mortar using ...

The experimental program involves casting of geopolymer mortar cubes by using GGBFS, Flyash and Quarry rock dust and testing them at 1 day, 3 days and 7 days for compressive strength. Different parameter considered in this study is alkaline fluid to binder ratio Keeping 12-Molarity of the alkaline liquid and the ratio of sodium hydroxide to ...

EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

to study the effect of partial replacement of fine aggregates by quarry dust and cement by fly ash on cement concrete. 1.2 NEED FOR INVESTIGATION Quarry Dust These residues are generally less than 1% aggregate production in the normal concrete. The introduction of quarry dust for mixing is limited due to its high fineness.

(PDF) Prediction of Compressive Strength and Water ...

Such models, if developed using statistical approaches, can also be used for studying mixture components’ interactions and optimization [8, 9]. Anya and Osadebe [10] developed models for predicting the compressive strength and water absorption of sand-quarry dust blocks using a statistical approach based on Scheffe’s simplex lattice design.

Compressive Strength and Water Absorption Characteristics ...

May 12, 2015 · Compressive strength tests were conducted in accordance with BS 3921:1985. Water absorptions of the samples were determined by using 24 h cold immersion test and 5 h boiling test. Bricks with mix ratio 1:0:10 (B5) containing 100 % quarry dust in replacing the sand gave the highest strength and the lowest water absorption compared to other ratios.

A STUDY OF COMPRESSIVE STRENGTH OF CONCRETE

examining of quarry dust to replace sand in concrete by using the water-cement ratio of 0.45 the average compressive strength of concrete specimens at 28 days is 323.36 ksc. The arisen problem during the mixing process of concrete by using quarry dust to replace sand is drying of the concrete then the water is needed more than normally.

disadvantages of quarry dust uses in concrete

Effective Utilization of Crusher Dust in Concrete Using ... - ijsrp.org. feasibility and potential use of crusher dust, a waste product from aggregate crushing plant in concrete mixes, in context of its compressive strength ..... “Compressive strength of concrete using lateritic sand and quarry dust as fine aggregate”. Read more

(PDF) EFFECT OF CHARACTERIZATION PROPERTIES ON COMPRESSIVE

effect of characterization properties on compressive strength of concrete containing quarry dust and waste plastic as fine aggregate. iaeme publication. ... 37 full pdfs related to this paper. read paper. effect of characterization properties on compressive strength of concrete containing quarry dust and waste plastic as fine aggregate ...

Effect of Marble Powder and Quarry Dust as Partial ...

Nov 22, 2019 · The compressive strength of concrete using partial replacement of quarry dust and marble powder as fine aggregate gives about 30% to 40% more strength than that of conventional concrete

amranfresno: AN INVESTIGATION ON EFFECT OF QUARRY DUST

Mar 01, 2012 · concrete strength. A study on the effect of quarry dust as sand replacement material on compressive and flexural strength of foam concrete was conducted. This study was conducted to determine the compressive strength and flexural strength of foam concrete by using quarry as partial sand replacement material.

The Utilization of Quarry Dust as Fine Aggregates in Concrete

75% & 100% in concrete & cubes were casted using this concrete containing quarry dust. The compressive strength of these cubes were tested after 7 days, 21 days & 28 days & the results thus obtained were compared to the compressive strength of the cubes made up of conventional concrete containing no quarry dust. 5 Results and Discussions

(PDF) An Experimental study on Effects of Quarry Dust as ...

Test Quarry dust is a byproduct of the crushing process which result gives that compressive strength of mould with 35% is a concentrated material to use as aggregates for of sand and 3% of cement replacing dust increases to concreting purpose, especially as fine aggregates. the rock 21.33% and 22.76% in that order compared to the normal has ...

EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

to study the effect of partial replacement of fine aggregates by quarry dust and cement by fly ash on cement concrete. 1.2 NEED FOR INVESTIGATION Quarry Dust These residues are generally less than 1% aggregate production in the normal concrete. The introduction of quarry dust for mixing is limited due to its high fineness.

Strength Assessment of Quarry Dust Treated Soil—Reclaimed ...

At 28 days of curing, river sand concrete exceeded the target compressive strength by 36%, whereas quarry dust concrete was less than the target compressive strength by 12%.

The effect of using quarry dust as a sand replacement ...

The effect of using quarry dust as a sand replacement material on compressive strength of concrete / ... Use of quarry dust as a fine aggregate in concrete draws serious attention of researchers and investigators. \ud Therefore, this study is the use of quarry dust, which is inert material or waste that is not useful, as a substitute for sand ...

Effect of Quarry Waste on Self-Compacting Concrete ...

Jul 31, 2016 · This paper presents the results of the experimental work conducted to study the effect of quarry waste on self-compacting concrete containing binary cementitious blends of fly ash and cement. For this purpose nine trial mixes were prepared, where the percentage replacement of river sand by quarry waste was 0%, 10%, 20%, 30%, 40%, 50%, 70%, and 100% to study

Mechanical properties of cold bonded quarry dust aggregate ...

Oct 30, 2016 · The effect of temperature, water binder ratio and aggregate ratio on strength of concrete containing quarry dust and fly ash is given in Table 3, Table 4 respectively. The variation of split tensile strength and modulus of elasticity was found to be similar to that of compressive strength.

A Study on Strength of Concrete With Partial Replacement ...

The present paper deals with partial replacement of cement with quarry dust and metakaolin which are having silica used as admixture for making concrete. First quarry dust is made partial replacement of cement and found that 25% of partial replacement is beneficial to concrete without loss of standard strength of cement.

Compressive Strength and Water Absorption Characteristics ...

May 12, 2015 · Compressive strength tests were conducted in accordance with BS 3921:1985. Water absorptions of the samples were determined by using 24 h cold immersion test and 5 h boiling test. Bricks with mix ratio 1:0:10 (B5) containing 100 % quarry dust in replacing the sand gave the highest strength and the lowest water absorption compared to other ratios.