replacement of fine aggregate with stone duste

replacement of fine aggregate with stone duste

replacement of fine aggregate with stone dust

International Journal of Science and Research (IJSR)625 Кб (2) Similarly replacement of fine aggregate by crushed glass powder is also found to be very effective.Effects of Crushed stone dust on some properties of concrete, Cement and Concrete Research 26(7), 1121-1130.

Utilization of Stone Dust as Fine Aggregate Replacement

2015-4-30 · The replacement of fine aggregate with stone dust does not give any harm on strength, it gives beneficial results. But it badly affects the workability on increment level of stone dust. So for maintain workability the dose of concrete was increased which affect the setting time and nearly doubled with comparison of conventional concrete. For attain good strength in this study the concrete with above 50% replacement level of stone dust casted on 1 - 1.5% dose of super plasticizer with slump vale of 25 – 35 mm. Finally it can be stated that the stone dust is to be used in concrete with partially or fully replacement of fine aggregate.

(PDF) Stone Dust as Partial Replacement of Fine Aggregate ...

60% and 70% partial replacement of fine aggregate with stone dust has been taken for concrete of M25 grade with 0.46 water cement ratio. In this study, set of cubes and

PARTIAL REPLACEMENT OF CEMENT AND FINE

2018-4-8 · investigation, stone dust, a waste material obtained from crusher plants is used as partial replacement of cement and fine aggregate. M25 grade of concrete was taken for this investigation with a final mix proportion of 1:1.79:2.92 at w/c ratio of 0.50. The replacement levels of cement and fine aggregate with stone dust were 5%, 10%, 15%.

Influence of stone dust as fine aggregate replacement on ...

2018-6-7 · concrete samples. It was found that the 10% of replacement increased the compressive strength of concrete; however, 5% of stone dust was adequate considering the impact resistance of the material. Topçu A Ugurlu8 used 5 replacement levels (3%, 7%, 10% and 15%) of natural sand aggregate by fine particles (sizes smaller than 2mm). The authors

Influence of stone dust as fine aggregate replacement on ...

2017-12-29 · The use of stone dust in concrete provides environmental benefits by reducing the impacts produced by the extraction of natural sand. The use of this material can also offer economic advantages, since the product is less costly than natural sand. In this way, the present work evaluated the compressive strength of concretes made with stone dust in different replacement levels (30% and

STUDY OF PARTIAL REPLACEMENT OF FINE AGGREGATE

2018-3-15 · FINE AGGREGATE 2.65 2 FINENESS MODULUS 2.8 Figure 1. Specific Gravity Of Fine Aggregate 3.3 Coarse Aggregate: The material whose particles are of size as retaine d on 4.75mm is sieve is termed as coarse aggregate. Coar se aggregate shall consist of crushed or broken stones and be hard, strong, dense, durable, clean or proper grada tion.

EFFECT OF REPLACING SHARP SAND WITH STONE DUST

2021-4-19 · Concrete is very variable material, having a wide range of strengths and stress-strain curve. Concrete composite material whose basic properties are related to the characteristic of constituent element, especially the aggregate. This research aimed to investigate the effect of replacing sharp sand with stone dust as an alternative to only river sand.

Effect of stone dust on strength of concrete

2021-7-4 · replacement of fine aggregate by stone dust is 60%. Replacement of 60% of fine aggregate by stone dust gave better strength at 7 days as well as at 28 days. They also specified that increase in strength might be due to change in the composition of matrix of concrete 8. Syam Prakash V., Krishnan D. and Jeenu G. investigated the

Replacement of Fine Aggregate by M-Sand - IJSTE

2017-7-7 · Coarse aggregate can be defined as inert granular materials such as gravel, crushed stone and sand. Coarse aggregate is one of the essential ingredients apart of water and cement in concrete production. It consists about 60 to 75 percent of total concrete production ... Replacement of Fine Aggregate by M-Sand (IJSTE/ Volume 3 / Issue 12 / 039)

PARTIAL AND COMPLETE REPLACEMENT OF FINE

2020-8-16 · About 20 kg of stone dust were bought and 20 kg of course as well as fine aggregate and 1 sac (50 kg) of cement was purchased. The demand of such building material is high in the market that is why they are easily available at any of the hardware shop. The stone dust will be mix in the fine aggregate in the ratio of 50% and 100% by weight.

(PDF) EXPERIMENTAL STUDY OF FINE AGGREGATE

Experimental programme was conducted using 30%, 40%, 50%, 60% and 70% partial replacement of fine aggregate with stone dust has been taken for concrete of M25 grade with 0.46 water cement ratio.

Influence of stone dust as fine aggregate replacement on ...

2018-6-7 · concrete samples. It was found that the 10% of replacement increased the compressive strength of concrete; however, 5% of stone dust was adequate considering the impact resistance of the material. Topçu A Ugurlu8 used 5 replacement levels (3%, 7%, 10% and 15%) of natural sand aggregate by fine particles (sizes smaller than 2mm). The authors

Influence of stone dust as fine aggregate replacement on ...

2017-12-29 · The use of stone dust in concrete provides environmental benefits by reducing the impacts produced by the extraction of natural sand. The use of this material can also offer economic advantages, since the product is less costly than natural sand. In this way, the present work evaluated the compressive strength of concretes made with stone dust in different replacement levels (30% and

STUDY OF PARTIAL REPLACEMENT OF FINE AGGREGATE

2018-3-15 · FINE AGGREGATE 2.65 2 FINENESS MODULUS 2.8 Figure 1. Specific Gravity Of Fine Aggregate 3.3 Coarse Aggregate: The material whose particles are of size as retaine d on 4.75mm is sieve is termed as coarse aggregate. Coar se aggregate shall consist of crushed or broken stones and be hard, strong, dense, durable, clean or proper grada tion.

EFFECT OF REPLACING SHARP SAND WITH STONE DUST

2021-4-19 · Concrete is very variable material, having a wide range of strengths and stress-strain curve. Concrete composite material whose basic properties are related to the characteristic of constituent element, especially the aggregate. This research aimed to investigate the effect of replacing sharp sand with stone dust as an alternative to only river sand.

7 III March 2019 doi.org/10.22214/ijraset.2019

stone dust and waste foundry sand as fine aggregate replacement. Fine aggregate are replaced partially with stone dust and waste foundry sand. The percentages of replacement 0%, 20%, 30%, 40%, 50% by weight of fine aggregate with stone dust and 0%, 10%, 15%, 20%, 25% by weight of fine aggregate with waste foundry sand.

Effect of stone dust on strength of concrete

2021-7-4 · replacement of fine aggregate by stone dust is 60%. Replacement of 60% of fine aggregate by stone dust gave better strength at 7 days as well as at 28 days. They also specified that increase in strength might be due to change in the composition of matrix of concrete 8. Syam Prakash V., Krishnan D. and Jeenu G. investigated the

Replacement of Fine Aggregate by M-Sand - IJSTE

2017-7-7 · Coarse aggregate can be defined as inert granular materials such as gravel, crushed stone and sand. Coarse aggregate is one of the essential ingredients apart of water and cement in concrete production. It consists about 60 to 75 percent of total concrete production ... Replacement of Fine Aggregate by M-Sand (IJSTE/ Volume 3 / Issue 12 / 039)

EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

2018-11-5 · aggregates generally consist of natural sand or crushed stone. Medium and fine sand are to be used in mortars. The properties of fine aggregate shall be in accordance with the requirements of IS: 383-197 The compressive strength, crushing value, etc. of the aggregate shall be in accordance with the requirements of IS: 383-1970

PARTIAL AND COMPLETE REPLACEMENT OF FINE

2020-8-16 · About 20 kg of stone dust were bought and 20 kg of course as well as fine aggregate and 1 sac (50 kg) of cement was purchased. The demand of such building material is high in the market that is why they are easily available at any of the hardware shop. The stone dust will be mix in the fine aggregate in the ratio of 50% and 100% by weight.

Influence of stone dust as fine aggregate replacement on ...

2018-6-7 · concrete samples. It was found that the 10% of replacement increased the compressive strength of concrete; however, 5% of stone dust was adequate considering the impact resistance of the material. Topçu A Ugurlu8 used 5 replacement levels (3%, 7%, 10% and 15%) of natural sand aggregate by fine particles (sizes smaller than 2mm). The authors

Influence of stone dust as fine aggregate replacement on ...

2017-12-29 · The use of stone dust in concrete provides environmental benefits by reducing the impacts produced by the extraction of natural sand. The use of this material can also offer economic advantages, since the product is less costly than natural sand. In this way, the present work evaluated the compressive strength of concretes made with stone dust in different replacement levels (30% and

civil engineering project replacement of fine aggregate ...

2013-6-12 · Reuse of Solid Waste from Building Demolition for the Replacement . replacement substitute to convectional coarse aggregate in concrete making of cubes, used in this project.Due to disposal of , Student, Department of Civil Engineering, JNT sieve is used as fine aggregate.The specific . Investigations on stone dust and ceramic scrap as aggregate replacement in

STUDY OF PARTIAL REPLACEMENT OF FINE AGGREGATE

2018-3-15 · FINE AGGREGATE 2.65 2 FINENESS MODULUS 2.8 Figure 1. Specific Gravity Of Fine Aggregate 3.3 Coarse Aggregate: The material whose particles are of size as retaine d on 4.75mm is sieve is termed as coarse aggregate. Coar se aggregate shall consist of crushed or broken stones and be hard, strong, dense, durable, clean or proper grada tion.

An Experimental study on Crushed Stone Dust as Fine ...

2018-1-1 · The deficit of natural sand arise the need of alternative materials for replacement of natural sand. This experimental study explores in detail the crushed stone dust which is locally available industrial solid waste material in India as alternative material to natural sand that is being conventionally used as fine aggregate in cement concrete.

An Experimental Investigation on Stone Dust as Partial ...

2014-10-11 · effectively used in partial replacement of fine aggregate in concrete. It is found that the compressive and flexural strengths of concrete increase on use of stone dust. The replacement level of the fine aggregate (30, 40, 50, 60 and 70%) by stone dust was investigated. It is observed that the compressive strength is not

7 III March 2019 doi.org/10.22214/ijraset.2019

stone dust and waste foundry sand as fine aggregate replacement. Fine aggregate are replaced partially with stone dust and waste foundry sand. The percentages of replacement 0%, 20%, 30%, 40%, 50% by weight of fine aggregate with stone dust and 0%, 10%, 15%, 20%, 25% by weight of fine aggregate with waste foundry sand.

Effect of stone dust on strength of concrete

2021-7-4 · replacement of fine aggregate by stone dust is 60%. Replacement of 60% of fine aggregate by stone dust gave better strength at 7 days as well as at 28 days. They also specified that increase in strength might be due to change in the composition of matrix of concrete 8. Syam Prakash V., Krishnan D. and Jeenu G. investigated the

EFFECT OF MARBLE POWDER AND STONE DUST BY

2018-8-13 · 10%, 20% and 30% along with replacement of fine aggregate with stone dust is 50%, 70% and 100% and the strength were compared with conventional concrete. In this study the set of cubes, cylinders and beams were casted for compressive strength, splint tensile strength and flexural strength respectively. The concrete specimens were tested after 7 ...